Filter
Top Products
E.
Cutting Pressure Control (E) - turn clockwise
to decrease cutting pressure. Turn counter-
clockwise to increase cutting pressure.
F.
Hydraulic On-Off Valve (F) - turns hydraulic
cylinder on and off.
Prior to Operation
1.
Check blade tooth direction matchesdiagram
on blade guides.
2.
Check to see that blade is properly seatedon
wheels after applying correct tension
(approximately 25,000 Ibs.).
3.
Set blade holder guides for approximately
.003" to .005" clearance betweenthe guides
and blade.
4.
Check for slight clearance between back up
rollers and back of blade.
5.
Position blade guides as close to work piece
as possible.
6.
Select proper speed and feed rate for material
being cut. See speed selectionchart found in
the enclosed "Guide to Bandsawing"booklet
supplied with this saw.
7.
Material to be cut must be securely held in
vise.
8.
Check to see that coolant level is adequate
and turn on coolant pump if materialto be cut
requires it. Machine should be filled with four
gallons of the propercoolant mixture. Follow
the directions on the product makers label and
fill the coolant tank through the chip tray area.
9.
Do not start cut on a sharp edge.
10. Keepmachinelubricated. See "Lubrication"
section.
4