Filter
Top Products
./
Tailstock Handwheel (A, Fig. 5) - turn clockwise to
move tailstock spindle forward. Turn counter-
clockwise to retract tailstock spindle.
Tailstock Spindle Lock (B, Fig: 5) - locks tailstock
spindle. Release to adjust handwheel.
Tailstock Lock (C, Fig. 5) - locks tailstock in
position on the bed. Release to move tailstock
assembly closer to or farther from the headstock.
Nomenclature and Use
Spur Center (A, Fig. 6) - locks into headstock and
holds the workpiece during spindle turning.
Index Pins (B, Fig. 6) - used to install and remove
spur center and face plate.
Face plate (C, Fig. 6) - attaches to headstock and is
used in face plate turning operations.
"-- Drift Rod (D, Fig. 6) - fits into the tailstock tO,remove
\ I the live center and into the headstock to removethe
' / live center..
Tool Rest (Fig. 7) - attaches to any location on the
bed or bed extension. Used to steady cutting tool
during spindle turning or face plate operations.
Adjusting Tool Rest
Position the tool rest as close to the work piece as
possible. It should be 1/8" above the centerline.
Position the tool rest base on the bed or bed
extension by releasing the lock handle (A, Fig. 7)
and sliding onto the desired position. Tighten handle
(A, Fig. 7) to lock. Adjust the height of the tool rest
by loosening handle (B, Fig. 7) and raising ,arm (C,
Fig. 7).
Should adjustment of the tool rest clamping device
become necessary, simply turn base over and adjust
~-, largenut(A, Fig.8).
d-
.- .--'--' _w- ---
7
-------
FIG-5
B
fl
c
I
fA
FIG-6
B
FIG-?
-,...,---
FIG.8