Filter
Top Products
Uncrating and Clean-Up
Note: Uncrating and assembly will require two
people due to the machines size and weight.
1.
Finish removing contents from the shipping
crate. Be sure to check crate thoroughly for
any parts not found on initial unpacking.
2.
Inspect contents for shipping damage and
report any damage to your distributor.
3.
Clean all protected parts with kerosene. Do not
use gasoline, paint thinner, or anyother
cellulose-based solvent. These will damage
painted surfaces and melt plastic.
Contents of Shipping Carton:
1 - Lathe bed wi motor and tailstock
1 - Tool rest wi extension
4
- Stand legs
2
- Long stand braces
2
- Short stand braces
2
- Stand tops
1 - Bed extension
1 - Face plate
1 - Drift rod
1 - Live center
1 - Spur center
2 - Index pins
1 - Face shield
1 - Hardware package (nuts, bolts, etc.)
1 - Operator's manual
1 - Warranty card
Tools Required for Assembly
NO.1 cross point screwdriver
NO.1 flat bladescrewdriver
Hex wrench set
Adjustable wrench or combinationwrenchset
Use of sockets and a ratchet will speed stand
assembly but are not required.
- _. -_.'.
".- -- -'--"-- - - -.,-- - - - .- 1
4