Filter
Top Products
11
Assembly
Read and understand all
assembly instructions before attempting
assembly! Failure to comply may cause
serious injury!
Unpacking and Cleanup
1. Remove all contents from the shipping carton.
Keep the saw table upside down (Figure 1) and
place on a two-by-four or similar piece of wood
under the rear of the saw. This will help when
picking up the table again. Do not discard the
carton of packing material until the saw is
assembled and is running satisfactorily.
2. Inspect the contents for shipping damage.
Report damage, if any, to your distributor.
3. Compare the contents of the shipping carton
with the contents list in this manual. Report
shortages, if any, to your distributor.
Figure 1
Stand Assembly
Refer to Figure 2.
Tool required – 12mm wrench
Mounting Hardware – the stand (excluding wheels)
is assembled using 24 each of the following: M8x16
carriage bolts (D), M8 flat washers (E), and M8
hex nuts (F).
The legs consist of one left front leg, one left rear
leg and two right legs. The left legs contain the
wheel mounting brackets and are not interchange-
able. The right legs are interchangeable. Refer to
Figure 2 for identification and orientation.
1. Assemble the front left and rear left legs (A, B)
to a long top plate (C) using the mounting
hardware listed above. Hand-tighten only at
this time. The long top plates have no cutouts.
Note: For entire assembly place plates inside legs.
2. Assemble the right legs (G
1
, G
2
) to the
remaining long top plate (C) in the same
manner.
3. Assemble the short top plate with the JET logo
(H) to the front stand legs (A, G
1
) using the
same combination of hardware as used to
attach the long top plates. Hand-tighten the
hardware only at this time.
4. Assemble the remaining short top plate (J) to
the rear stand legs (B, G
2
) in the same manner.
5. Assemble two long support plates (K) to the
inside of the left stand legs (A, B) and right
stand legs (G
1
, G
2
) respectively with the same
hardware. Hand-tighten only at this time.
Note: The long support plates have no cutouts.
Figure 2
6. Assemble two short support plates (L) to the
inside of the front stand legs (A, G
1
) and rear
stand legs (B, G
2
) respectively with the same
hardware. Hand-tighten only at this time.
Note: The short support plates have cutouts.
7. Assemble two wheels (M) to the left legs with
two 3/8”-16 x 2.5” hex cap screws (N) and two
3/8”-16 nylon insert lock nuts (O) and tighten
with two 13mm wrenches.
8. Place two wheel lock knobs (P) on the brackets
above the wheels.
9. Attach wheel pad assemblies to the right legs
(no wheels), each assembly consisting of one
threaded wheel pad (Q), two 5/16" hex nuts (R)
and two M8 flat washers (S).