Filter
Top Products
15
three turns of the cutter in a carpenter's brace
chuck should be enough to sharpen the chisel,
as shown in Figure 16.
Use a small, triangular, smooth file to relieve
the inner corners of the chisel (Figure 17).
Remove any burrs from the outside of the
chisel with a fine oilstone.
Lubrication
All of the ball bearings are packed with grease
at the factory. They require no further
lubrication.
Periodically grease the gears, racks, and table
pivot points with a #2 tube grease.
Periodically clean and oil any exposed machine
surfaces, such as: dove-tail ways and slides,
and table surface.
Figure 17
Parts
Replacement Parts
Replacement parts are listed on the following pages. To order parts or reach our service department, call
1-800-274-6848 between 7:00 a.m. and 6:00 p.m. (CST), Monday through Friday. Having the Model
Number and Serial Number of your machine available when you call will allow us to serve you quickly and
accurately.