Filter
Top Products
– 24 –
FIGURE 2
CUTTING TORCH CONNECTION DIAGRAM
Do not operate with covers removed
Disconnect input power before servicing
Do not touch electrically live parts
Only qualified persons should install,
use or service this equipment
THE LINCOLN ELECTRIC CO. CLEVELAND, OHIO U.S.A.
PILOT
WORK
TM
PRO-CUT 60 POWER SOURCE
PLASMA TORCH
FOR MAGNUM PCT 60
2. INSERT TORCH CABLE THROUGH CABLE BOOT.
TURN AND LOCK STRAIN RELIEF CLAMP ONTO
BOLT.
SCREW TIGHT.
5. ATTACH AMPHENOL CONNECTOR.
3. CONNECT PILOT LEAD.
ADAPTER
GAS LINE
BOLT
STRAIN RELIEF CLAMP
CABLE BOOT
WORK LEAD
7-26-91C
1. DISCONNECT INPUT POWER TO THE PRO-CUT
AND TURN MACHINE POWER SWITCH OFF.
AMPHENOL
CONNECTOR
PILOT
LEAD
S19941
4. PLACE GAS LINE FITTING ON ADAPTER AND
May96