Filter
Top Products
**&) *
. ))&'+ &%*
.:C6665$@5F=6"
Provides constant voltage (CV) output with improved
arc stability for Innershield welding. Excellent for MIG
welding. Recommended wire feeders are the LN-7,
LN-23P and LN-25. (Factory installed on the K1643-
2).
LN-25 Wire Feeder K449
Portable CC/CV unit for flux-cored and MIG welding.
Includes Gas Solenoid & Internal Contactor. Requires
Wire Feed Module.
Remote Voltage Control Kit for LN-25 "
Provides 25 ft. (7.5m) of remote output voltage control
and output jumper (2 and 4) for machines having 14
pin MS-type connector.
Magnum® 350 Innershield Gun for LN-25 K126-2
For self-shielded wire with 15 ft. (4.5m) cable. For
.062-3/32” (1.6-2.8mm) wire.
Magnum® 300 MIG Gun for LN-25 "
With 15 ft. (4.5m) cable. For .035”-.045” (0.9-1.2mm)
gas shielded (Includes Connector Kit).
LN-23P Wire Feeder K316L-1
Portable CV unit for Innershield pipe welding. Control
cable operates contactor inside Wire Feed Module for
“cold” electrode. Requires LN-23P Adapter Kit (K350-
1) and Gun and Cable Assembly.
LN-23P Adapter Kit K350-1
Required to adapt LN-23P to any Lincoln power
source. Makes 14 pin connection at power source.
$28?F>R ??6CD9:6=5F?7@C#%'K355-10
For lighter weight and easier handling. Rated 250
amps, 60% duty cycle. For .068 through 5/64” (1.7
through 2.0 mm) Innershield wire and includes
reduced speed switch. For pipewelding, an M11476
62° gun tube is recommended.
P8F?EF367@C':A6.6=5:?8"'
Recommended modification for K355-X or K345-x
guns with 90° gun tubes. Compatible with K126-1,-2,
K264-8 and K355-10.
Magnum Spool Gun K487-25
Hand held semiautomatic wire feeder requires SG
Control Module. 25 ft. length.
SG Control Module K488 (For Magnum Spool Gun)
The interface between the power source and the
spool gun. Provides control of wire speed and gas
flow.
Input Cable K691-10 ( For SG Control Module)
For Lincoln engine drives with 14-pin MS-type con-
nection, separate 115V NEMA receptacle and output
stud connections. 10 ft. length.
#** R')" %*