Filter
Top Products
– 13 –
ENGINE OPERATION
Operate the welder with the doors closed. Leaving
the doors open changes the designed air flow and can
cause overheating.
Starting the Perkins D3.152 Engine
a) Turn the idler control to “HIGH”.
b) Turn the ignition control to “ON”.
c) Push in the “RESET” button.
d) Press the “START” button. Release button when
engine starts.
e) If the engine fails to start in 60 seconds, wait 30
seconds before repeating the above procedure.
f) Allow the engine to run at high idle speed for
several minutes to warm up. Cold engines tend to
run at a speed too slow to supply the voltage
required for proper idler operation.
Cold Weather Starting -- When overnight
temperatures are between -12°C (10°F) and freezing,
use the standard “Thermostart” starting system
installed on all engines. Follow the instructions on the
nameplate and in the engine manual shipped with the
welder. With fully charged batteries and the proper
weight oil, the “Thermostart” system operates
satisfactorily even down to about -18°C (0°F).
If the engine must be frequently started below -12°C
(10°F), it may be desirable to remove the
“Thermostart” and install the optional ether starter kit.
Installation and operating instructions are included in
the kit. Use ether starting only when required
because excessive use shortens engine life.
Stopping the Perkins D3.152 Engine
a) Turn the ignition control to “OFF”.
At the end of each day’s welding, refill the fuel tank to
minimize moisture condensation in the tank. Also,
running out of fuel tends to draw dirt into the fuel
system.
Check the crankcase oil and radiator water level.
Do not attempt to use this equipment until you
have thoroughly read the engine manufacturer’s
manual supplied with your welder. It includes
important safety precautions, detailed engine
starting, operating and maintenance instructions,
and parts lists.
------------------------------------------------------------------------
ELECTRIC SHOCK can kill.
• Do not touch electrically live parts or
electrode with skin or wet clothing.
• Insulate yourself from work and
ground
• Always wear dry insulating gloves.
------------------------------------------------------------------------
ENGINE EXHAUST can kill.
• Use in open, well ventilated areas or
vent exhaust outside.
------------------------------------------------------------------------
MOVING PARTS can injure.
• Do not operate with doors open or
guards off.
• Stop engine before servicing.
• Keep away from moving parts.
------------------------------------------------------------------------
See additional warning information at
front of this operator’s manual.
-----------------------------------------------------------
WARNING