Filter
Top Products
– 8 –
OPTIONAL FEATURES
Accessory Set (K703)
Includes electrode and work cables, headshield, work
clamp, and electrode holder.
Ether Start Kit (K793) for Perkins Engine
When frequent starting is expected below
-12°C, (10°F) remove the “thermostart” system and
install the optional ether start kit to provide maximum
cold weather starting assistance. Ether starting
should only be used as required since indiscriminate
application will contribute to shortened engine life.
(Available for field installation only).
Hi-Freq™ (K799)
Provides high frequency plus gas valve for DC TIG
welding. (Request Publication E385).
Optional field installed water valve kit available. Order
K844.
Linc-Thaw™ (L2964-5) Control Unit
Includes meter and fuses to protect welder when
thawing frozen water pipes.
Pipe Thawing IS
NOT a CSA approved procedure.
If not done properly, it can result in fire, explosion,
damage to wiring which may make it unsafe,
damage to pipes, burning up the welder, or other
hazards.
Do not use a welder to thaw pipe before reviewing
Lincoln Bulletin E695.1 (dated October 1987 or later.)
------------------------------------------------------------------------
Mufflers
Mufflers are standard on the 350-SA Perkins.
Power Plug Kit (K802C)
• A power plug kit for the auxiliary power receptacles
is available. (Provides a plug for each receptacle).
Trailer (K769)
Two-wheeled trailer for in-plant and yard towing only.
(For highway use, consult applicable federal, state,
and local laws regarding possible requirements for
brakes, lights, fenders, etc.)
Trailer (K913)
Two-wheeled highway trailer with steel, torsion-bar
axle, 54” (137cm) wheel track. Low sway, low center-
of-gravity. Sturdy tread plate platform. Choice of 3
hitches. Add on fender & light package. For highway
use, consult applicable local laws regarding possible
additional requirements.
Order: K913-1 Base Trailer
K913-2 Ball Hitch
K913-3 Lunette Eye Hitch
K913-4 Clevis Pin Hitch
K913-5 Fender & Light Kit
Wire Feed Module (K623-1)
The Wire Feed Module is field-installed on the K1314-4
and factory-installed on the K1314-5 to provide CV
(constant voltage) output for semiautomatic welding.
Output rated at 250 Amps at 35 Volts with a 60% Duty
Cycle and 310 Amps at 32 Volts with a 35% Duty
Cycle.
DIMENSIONS
See dimension Print M8869-24 at the rear of this
manual.
WARNING