Filter
Top Products
F-30
TROUBLESHOOTING AND REPAIR
F-30
POWER MIG® 215
PROCEDURE
1. Remove power to the machine.
2. Lift cover to gain access to the wire drive.
See Figure F.9.
3. Using a pair of pliers, disconnect the gas
hose from the bottom of the wire drive.
See Figure F.10.
4. Using a 9/16” nut driver, remove the thick
black positive lead located just above the
gas hose. See Figure F.10.
NOTE: Disconnect lead from the wire drive
motor assembly, not the machine.
5. Using a 5/16” nutdriver, remove the three
mounting screws next to the wire drive
assembly. See Figure F.10.
6. Using a 5/16” nutdriver, remove the two
screws on the case front assembly. See
Figure F.11.
7. Carefully maneuver the wire drive assem-
bly out the side of the machine to gain
access to plug J4. See Wiring Diagram.
8. Disconnect plug J4.
WIRE DRIVE MOTOR ASSEMBLY REPLACEMENT (Continued)
Wire Drive
FIGURE F.9. - WIRE DRIVE LOCATION
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC