Filter
Top Products
15
To attach the vacuum head on the tool, insert the hooks of
the vacuum head into the hole in the base. The vacuum head
can be installed on either left or right side of the base.
Then connect a Makita vacuum cleaner to the vacuum head.
OPERATION
CAUTION:
• Always hold the base flush with the workpiece. Failure to
do so may cause blade breakage, resulting in a serious
injury.
• Advance the tool very slowly when cutting curves or
scrolling. Forcing the tool may cause a slanted cutting
surface and blade breakage.
Turn the tool on without the blade making any contact and
wait until the blade attains full speed. Then rest the base flat
on the workpiece and gently move the tool forward along the
previously marked cutting line.
NOTE:
• If the tool is operated continuously until the battery
cartridge has discharged, allow the tool to rest for 15
minutes before proceeding with a fresh battery.
1. Vacuum head
2. Base
1
2
002741
002742
1. Cutting line
2. Base
1
2
002745