Filter
Top Products
19
Installing clamp
1. Make sure that the blade installing lever has been
rotated in the (4) direction until it stops.
2. Insert the clamp into the blade holder while rotating it in
the (6) direction one quarter to one full turn so that its
slot will face forward.
CAUTION:
• Do not rotate the clamp more than one full turn when
inserting in into the blade holder. If you do so, the blade
may not be tightened firmly.
3. Grasp the clamp with your fingers so that it will not turn,
then rotate the blade installing lever in the (7) direction
until it stops. The clamp will go in the blade holder.
Replacing carbon brushes
Remove and check the carbon brushes regularly. Replace
when they wear down to the limit mark. Keep the carbon
brushes clean and free to slip in the holders. Both carbon
brushes should be replaced at the same time. Use only iden-
tical carbon brushes.
(4)
002782
1. Blade holder
2. Clamp
1
2
(6)
002783
1. Blade installing lever
(7)
1
002784
1. Limit mark
1
001145