Filter
Top Products
ASSEMBLY
Installing or removing driver bit or drill bit
CAU TI
0
N
:
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the bit.
Turn the sleeve counterclockwise
to
open
the chuck jaws. Place the bit in the chuck
as
far
as it will go. Turn the sleeve clock-
wise to tighten the chuck.
To
remove the bit, turn the sleeve counter-
clockwise.
When not using the driver bit, keep it in the
bit holders. Bits 45 mm (1-3/4") long can
be kept there.
Side grip (auxiliary handle)
Always use the side grip to ensure operat-
ing safety. Install the side grip
so
that the
teeth on the grip fit in between the protru-
sions on the tool barrel.
Then tighten the grip by turning clockwise
at the desired position. It may be swung
360"
so
as to be secured at any position.
-
Bit
Bit
holder
I
Teeth
Side
grip
Loosen Tighten
12