Filter
Top Products
If
you charge
a
battery cartridge from
a
just-operated tool or
a
battery cartridge which has
been left in
a
location exposed
to
direct sunlight
or
heat for
a
long time, the charging light
may flash in red color
If
this occurs, wait for
a
while Charging will begin after the battery
cartridge cools The battery cartridge will
cool
faster
if
you remove the battery cartridge
from the high capacity battery charger
If
the charging light flashes alternately in green and red color,
a
problem exists and charg-
ing is not possible The terminals on the charger or battery cartridge are clogged with
dust or the battery cartridge
IS
worn out or damaged
Trickle charge (Maintenance charge)
If
you leave the battery cartridge in the charger to prevent spontaneous discharging after
full charge, the charger will switch into its "trickle charge (maintenance charge)" mode and
keep the battery cartridge fresh and fully charged.
Tips for maintaining maximum battery life
1.
Charge the battery cartridge before completely discharged.
Always stop tool operation and charge the battery cartridge when you notice less tool
power.
2.
Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
3.
Charge the battery cartridge with room temperature at
10°C
-
40°C (50°F
-
104°F).
Let
a
hot battery cartridge cool down before charging it.
Switch action
CAUTION
Before inserting the battery cartridge into the tool, always check to see that the switch
trigger actuates properly and returns
to
the "OFF" position when released
To start the tool, simply pull the trigger
Tool speed is increased by increasing pres-
sure on the trigger Release the trigger to
stop
9