Filter
Top Products
ASSEMBLY
Removing
or
installing the punch and die
CAUTION:
Always be sure that the tool is switched off and unplugged before removing or installing
the punch and die.
Always replace the punch and die as
a
set. To remove the punch and die, loosen the lock
nut with the wrench. Remove the die holder from the tool. Use the hex wrench to loosen
the bolts which secure the die. Remove the die from the die holder. Use the hex wrench
to loosen the screw which secures the punch. Pull the punch out
of
the punch holder,
Hex wrench
Bolts
I
I
A
To install the punch and die, insert the punch into the punch holder
so
that the notch in the
punch faces toward the screw. Tighten the screw to secure the punch. Install the die on
the die holder. Tighten the bolts to secure the die. Then install the die holder on the
machine
so
that the punch is inserted through the hole in the die holder. Tighten the lock
nut to secure the die holder. After replacing the punch and die, lubricate them with
machine
oil
and run the machine for a while.
I
Bolts
D1e=E
5