Filter
Top Products
.
OPERATION
Changing the die position
CAUTION:
Always be sure that the tool
is
switched off and unplugged before changing the die posi-
tion.
To switch on, depress the rear of the
switch lever and push
it
forward. Then
depress the front
of
the switch lever to
The die position can be changed
360".
To
Switch
lever
-,
change
it,
proceed as follows.
1.
Loosen the lock nut with the wrench
provided.
2.
Pull the die holder slightly and turn it to
the desired position for operation.
3.
Tighten the lock nut to secure the die
holder in the desired position.
Die
\+
There are four positive stops at
90"
each:
0".
90"
left and right and
180".
To position the
die to any of these positive stops:
1.
Loosen the lock nut with the wrench provided.
2.
Pull the die holder slightly and depress lightly while turning
it
to the desired position.
3.
Turn the die holder slightly to make sure that it is positively locked into position.
4.
Tighten the lock nut to secure the die holder.
The die holder will lock into one
of
the positive stop positions as desired.
6