Filter
Top Products
OM-220 389 Page 16
4-5. Selecting A Location
loc_2 3/96 -Ref. 803 410-B
! Do not stack units. Beware of
tipping.
1 Lifting Forks
Use lifting forks to move unit.
Extend forks beyond opposite side
of unit.
2 Hand Cart
Use cart or similar device to move
unit.
3 Rating Label
Use rating label to determine input
power needs.
4 Line Disconnect Device
Locate unit near correct input
power supply.
Movement
2
Location
4
18 in
(460 mm)
18 in
(460 mm)
3
! Do not move or operate
unit where it could tip.
Tipping
1
OR
! Special installation may be required where gasoline or volatile
liquids are present − see NEC Article 511 or CEC Section 20.
Ref. 803 410-B / Ref. 801 915-A
1 Welding Power Source
2 Wire Feeder
3 Gas Cylinder
4 Gas Hose
5 Network Feeder Cable
6 Negative (−) Weld Cable
7 Workpiece
8 Work Sense Lead
Recommended for Accu-pulse and
RMD (optional).
. Positive (+) voltage sensing
lead is contained in the motor
cable.
9 Positive (+) Weld Cable
1
2
3
4
5
7
8
9
4-6. Connection Diagram
6