Filter
Top Products
. Complete Parts List available at www. MillerWelds.com
OM-228 042 Page 25
1 Wire Spool
2 Welding Wire
3 Inlet Wire Guide
4 Pressure Adjustment Knob
5 Drive Roll
6 Gun Conduit Cable
Lay gun cable out straight. Open
pressure assembly.
Pull about 6 in. (150 mm) of wire off
spool. Hold tightly to keep it from
unraveling. Cut off end.
Pull wire through guides into gun;
continue to hold wire tightly.
Be sure wire is positioned in proper
feed roll groove. Close and tighten
pressure assembly. Let go of wire.
Use pressure indicator scale to set
desired drive roll pressure. Begin
with a setting of 3. If necessary,
make additional adjustments after
trying initial setting.
Remove gun nozzle and contact
tip.
Turn power on.
Press gun trigger until wire comes
out of gun.
Be sure that tip matches wire diam-
eter. Reinstall contact tip and
nozzle.
Feed wire to check drive roll pres-
sure. Tighten knob enough to pre-
vent slipping. Cut off wire.
Close door.
WOOD
Tighten
1
2
3
4