Filter
Top Products
OM-1500-19 Page 15
4-3. Equipment Connection Diagram
Ref. 804 000-C
! Turn Off wire feeder and
welding power source. Stop
engine on welding
generator.
! Use only with CC/CV DC
Power Sources.
1 Constant Current (CC) or
Constant Voltage (CV)
Welding Power Supply
2 Weld Cable To Feeder
3 Ground Cable To Workpiece
Weld cable and ground cable con-
nections to power source (DCEN/
DCEP) are dependant on wire type.
. Since feeder is not polarity sen-
sitive, there is no need for an
electrode polarity switch.
4 Workpiece
5 Voltage Sensing Clamp
Connect voltage sensing clamp to
workpiece.
6 Gun
7 Gun Trigger Receptacle
8 Wire Feeder
9 Gas Hose
10 Gas Cylinder
Use of shielding gas is dependant
on wire type.
. Shielding gas pressure not to
exceed 100 psi (689 kPa).
1
2
3
4
8
9
10
6
7
5
Notes