Filter
Top Products
OM-1500-19 Page 19
4-9. Installing And Threading Welding Wire
Ref. 804 005-B
Installing Wire And Adjusting
Hub Tension:
1 Retaining Nut
2 Hub Tension Adjustment Knob
Remove retaining ring, and install
spool so hub pin fits spool hole. Re-
install retaining nut.
Adjust tension knob so only a slight
force is needed to turn spool.
Threading Welding Wire:
3 Pressure Assembly
Adjustment Knob
Lay gun cable out straight.
Open pressure assembly, hold wire
tightly, and cut off end. Push wire
through guides into gun.
Close and tighten pressure assem-
bly. Press jog switch until wire
comes out gun.
Feed wire against wooden surface,
and tighten knob so wire does not
slip.
Cut off wire, and close door.
Pull and hold wire; cut off end.
6 in
(150 mm)
1
2
3
WOOD
Tighten
Clockwise
. Hold wire tightly to keep
it from unraveling.