Filter
Top Products
9
P/N: 307271
SECTION 1 SAFETY
1.1 PARKING
CHOOSING A PARKING SITE
1. Park the compressor on a level firm area. Never park on a grade of more than 15 degrees (27%).
If you must park on any grade, park across the grade so that the compressor does not tend to roll.
2. Park so that the wind carries exhaust fumes and radiator heat away from the compressor inlet.
3. Park away from work site dust.
4. Stay clear of electrical power lines. Keep the towing vehicle or equipment carrier, compressor,
hoses, tools and all personnel at least 10 feet from power lines and buried cables.
1.2 BEFORE STARTING THE COMPRESSOR
1. Check fluids levels and for possible leaks.
2. Use adequate hose and couplings with safety locks or pins.
3. Remove all tools and/or loose items from engine compartment.
4. Relieve any pressure in receiver tank.
5. Use proper eye and ear protection.
1.3 COMPRESSOR USE AND COMPRESSED AIR
1. Air from this machine is not fit for human breathing or food processing.
2. Never operate in an enclosed area.
3. Never use compressed air to clean your clothes and never direct it at another person, it can kill.
4. Always wear eye protection.
5. Install velocity fuse (“OSHA”) upstream of hose to prevent hose whip in case of a rupture.
6. Keep doors or hoods closed on machines in operation.
7. Do not touch hot surfaces or moving parts, such as exhaust or fans.
8. Do not adjust or restrict relief valves.
9. Do not refuel while machine is running; shut down and allow to cool before refueling.
10. Do not jump-start with cable connections directly on battery.
12. Do not use air at pressure higher than 30 PSIG (207 KPA) for cleaning purposes. Use of higher air
pressure can cause injury to the operator.
13. Keep compressor panels closed except when making repairs, adjustments, or servicing the
compressor.
14. Make sure all personnel are out of and clear of the compressor before starting or operating it.
15. Do not use either cylinder or air line antifreeze compound in confined area.