Filter
Top Products
19
EN
Care and maintenance
5. Cleaning and daily disinfecting
5.1 Cleaning
Following the cleaning instructions after each use will prevent any remaining
medication in the tank from drying, resulting in the device not nebulising effectively
and also for preventing infections.
Warning:
Thoroughly rinse the nebuliser and the mask, nosepiece or mouthpiece with
clean hot tap water after each use, and disinfect the parts of the nebuliser kit
and applicable inhalation attachments after the last treatment of the day.
Note: Do not start operation before the cleaned parts are completely dried.
1. Make sure that the power indicator is out.
2. Disconnect the AC adapter from the wall outlet
and the compressor.
3. Remove the nebuliser kit from the air tube and disassemble the nebuliser
kit. (see Section 3)
4. Discard any remaining medication in the
medication tank.
5. Wash all the nebulising parts in warm water and mild detergent and rinse in
clean hot tap water, or wash in a dishwasher.
For instructions on how to disinfect the parts, see the following section.
Power Indicator
m
ax
5
3
NE-C30_main.book Page 19 Tuesday, December 13, 2011 12:14 PM