Filter
Top Products
C4603M-A (5/09) 5
STRAIGHT THROUGH CABLE
To configure your network settings using a straight through cable (refer to Figure 2):
1. Connect a standard network cable from Ethernet port 1 to the Endura network.
2. Connect one end of the straight through cable to the network connector on the laptop.
3. Connect the other end of the straight through cable to a network switch.
4. Connect a second straight through cable from the network switch to Ethernet Port 2 located on the NSM5200 back panel.
5. Turn on your laptop.
6. Start the NSM5200. It will take approximately 10 to 15 minutes for the unit to turn on completely.
NOTE: To prevent IP and routing conflicts, make sure that only the laptop and the NSM5200 are connected to the network switch.
Figure 2. Straight Through Cable Setup
7. Configure the network settings on the laptop.
• IP address: 172.31.255.253
• Subnet Mask: 255.255.255.0
8. Click OK or Apply.
9. Open a Web browser, and then enter the following IP address: 172.31.255.254. The Web browser login dialog box appears.
10. Type admin (the default password) to log on to the Web application. The setup screen for the Pool Manager appears (refer to Figure 3 on
page 6).
NOTE: For security purposes, change the password after you log on for the first time (refer to Figure 7 on page 10).
STRAIGHT THROUGH
CABLE
SWITCH
STRAIGHT THROUGH
CABLE
LAPTOP
NSM5200
ENDURA NETWORK