Filter
Top Products
9
ATTACHING THE SWITCH
A push-button switch (mounted in a switch box) and a cord set are supplied with the unit. To attach the switch to the band saw
arm:
DISCONNECT MACHINE FROM POWER SOURCE.
The on/off switch-to-motor cord (F) Fig. 11 is tied to the vertical mounting post (G) opposite the motor pulley. The
cable tie (H) prevents the switch-to-motor cord (F) from contacting the belt or motor pulley during operation.
LEA
VE THIS CABLE TIE IN PLACE. Remove it ONLY when using the Accessory Height Attachment with the
machine.
1. Remove the two outer hex nuts and lock washers (A) Fig. 12 from the two screws extending out from the back of the switch
box (B).
2. Insert two screws (C) Fig. 13, located on back of switch box, into two holes (D) located in the band saw arm.
3. Use the two nuts and lockwashers (E) Fig. 14, removed in STEP 1, to fasten the switch box to the bandsaw arm (Fig. 14).
4. Remove the screw and cable clamp (E) Fig. 15 from the lower arm of the band saw.
5. Insert the switch cord into the clamp (E) (removed in STEP 4), and fasten the switch cord to the machine.
Prevent contact between the on/off switch-to-motor cord (F) Fig. 16 and the motor pulley or belt. If necessary,
adjust the cord, then tighten the cable tie (H) Fig.11.
6. Attach the two side panels removed earlier.
Fig. 11
Fig. 12
Fig. 13
Fig. 14
A
B
C
D
E
IMPORTANT:
Fig. 15
E
IMPORTANT: