Filter
Top Products
6
UNPACKING
1. Remove the miter saw and all loose items from the
carton. IMPORTANT: DO NOT LIFT THE MITER SAW
BY THE SWITCH HANDLE AS THIS MAY CAUSE
MISALIGNMENT. ALWAYS LIFT THE MACHINE BY
THE BASE OR CARRYING HANDLE (see (D) Fig. 4A.
Fig. 2 illustrates the machine and all loose items after
they have been removed from the carton.
1 - Miter Saw
2 - Dust Bag
3 - Wrench for changing the blade
4 - Clamp
5 - Table Extension (2)
Fig. 2
2
4
3
1
ASSEMBLY INSTRUCTIONS
WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER
SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND
UNDERSTOOD THE ENTIRE OWNER’S MANUAL.
Fig. 3
Fig. 4
MOVING THE CUTTINGHEAD TO THE
RAISED POSITION
1. Push down on handle (A) Fig. 3, to release spring
pressure. Then pull out cuttinghead lockpin (B) and
move cuttinghead (C) to the raised position.
2. Fig. 4, illustrates the lockpin (B) pulled out and the
cuttinghead (C) in the raised position.
Fig. 4A
ASSEMBLING TABLE EXTENSIONS
Remove two screws from each extension rods.
Assemble ends of table extension (A) Fig. 4A, onto the
extension rods (B) as shown. Tighten screws (C) to hold
table extension in place.
5
A
B
C
A
B
C
B
C
D