Filter
Top Products
21
KEEP TOOL CLEAN
Periodically blow out all air passages with dry compressed air. All plastic parts should be cleaned with a soft damp cloth.
NEVER use solvents to clean plastic parts. They could possibly dissolve or otherwise damage the material.
Wear ANSI Z87.1 safety glasses while using compressed air.
FAILURE TO START
Should your tool fail to start, check to make sure the prongs on the cord plug are making good contact in the outlet.
Also, check for blown fuses or open circuit breakers in the line.
LUBRICATION
This tool has been lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal
operating conditions. No further lubrication is necessary.
BRUSH INSPECTION (If applicable)
For your continued safety and electrical protection, brush inspection and replacement on this tool should ONLY be
performed by an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER-CABLE•DELTA FACTORY SERVICE
CENTER.
At approximately 100 hours of use, take or send your tool to your nearest authorized Porter-Cable Service Station to be
thoroughly cleaned and inspected. Have worn parts replaced and lubricated with fresh lubricant. Have new brushes
installed, and test the tool for performance.
Any loss of power before the above maintenance check may indicate the need for immediate servicing of your tool. DO
NOT CONTINUE TO OPERATE TOOL UNDER THIS CONDITION. If proper operating voltage is present, return your tool
to the service station for immediate service.
A complete line of accessories is available from your Porter-Cable·Delta Supplier, Porter-Cable·Delta Factory Service
Centers, and Porter-Cable Authorized Service Stations. Please visit our Web Site www.porter-cable.com for a
catalog or for the name of your nearest supplier.
Since accessories other than those offered by Porter-Cable·Delta have not been tested with this
product, use of such accessories could be hazardous. For safest operation, only Porter-Cable·Delta
recommended accessories should be used with this product.
ACCESSORIES
REPLACEMENT PARTS
When servicing use only identical replacement parts.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due to wear from normal use. These operations,
including brush inspection and replacement, should ONLY be performed by either an AUTHORIZED PORTER-CABLE
SERVICE STATION or a PORTER-CABLE·DELTA FACTORY SERVICE CENTER. All repairs made by these agencies are
fully guaranteed against defective material and workmanship. We cannot guarantee repairs made or attempted by
anyone other than these agencies.
Should you have any questions about your tool, feel free to write us at any time. In any communications, please give
all information shown on the nameplate of your tool (model number, type, serial number, etc.).
SERVICE