Filter
Top Products
10- ENG
4. Guide the straight end of each retaining
Handle
Inserted
On Tabs
Retaining
Clip
Handle
clip through the saddle hole and both
handle holes.
5. Rotate each retaining clip and press
down until it snaps into place over the
handle.
6. If the handle has excessive movement,
it is improperly installed. Check the
following.
A. Are both tabs inside the handle?
B. Does each clip pass through both
the saddle and handle?
TO ASSEMBLE WHEELS
It will be necessary to brace or
Wheel
Shoulder Bolt
Nut
support one side of the unit when installing
the wheels because the compressor will have
a tendency to tip.
1. Attach wheels with shoulder bolts and
nuts as shown.
2. Tighten securely. NOTE: The unit will sit
level if the wheels are properly installed.
The wheels and handle do
not provide adequate clearance, stability or
support for pulling the unit up and down
stairs or steps. The unit must be lifted, or
pushed up a ramp.
ASSEMBLE RUBBER FEET
Screw
Nut
Flat
Washer
Rubber Foot
1. Attach rubber feet with the screws,
washers, and nuts provided as shown.
2. Tighten securely.
INSTALLATION
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
• Locatetheaircompressorinaclean,dryandwellventilatedarea.
• Theaircompressorshouldbelocatedatleast12"(30.5cm)awayfromthe
wall or other obstructions that will interfere with the flow of air.
• Theaircompressorpumpandshroudaredesignedtoallowforpropercooling.
Do not place rags or other objects on top of compressor.