Filter
Top Products
9 - ENG
DUTY CYCLE
This air compressor pump is capable of running continuously. However, to prolong
the life of your air compressor, it is recommended that a 50%-75% average duty
cycle be maintained; that is, the air compressor pump should not run more than
30-45 minutes in any given hour.
ACCESSORIES
Accessories for this unit are available at the store the unit was purchased.
The use of any other accessory not recommended for use
with this tool could be hazardous. Use only accessories rated equal to or
higher than the rating of the air compressor.
ASSEMBLY
TOOLS REQUIRED FOR ASSEMBLY
1 - 9/16" socket or open end wrench
1 - 1/2" socket or open end wrench
UNPACKING
Remove unit from carton and discard all packaging. NOTE: Save all parts bags.
This compressor was shipped with oil in the pump crankcase.
Check oil before operating air compressor, see Check Oil under Maintenance.
TO INSTALL HANDLE
The wheels and handle do not provide adequate clearance,
stability, or support for pulling the unit up and down stairs or steps. The unit must
be lifted or pushed up a ramp. Do not lift the unit by the manifold assembly, the
unit could be damaged.
1. To make installation easier, submerge handle grip into warm soapy water.
Remove handle grip from soapy water and slide onto handle.
2. Insert the open end of the handle under the saddle. Before attaching handle,
you may have to pull the open ends of the handle apart so they fit tightly
against the side of the saddle. Looking in from the open end of the saddle,
position the handle toward the two bent tabs, on the inside walls of the
saddle.
3. Slowly push the open ends of the handle onto both tabs at the same time.
Continue pushing the handle into the saddle until the holes on the side of the
saddle and handle are in line.
Saddle Hole
Handle
Hole
Bent Tabs
Open End
Of Handle
Bent Tabs
Saddle
Open End
Of Handle
Open
End Of
Saddle