Filter
Top Products
11
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
IMPORTANT: Changes or modifications to this product not authorized by
Porter-Cable Corporation, could void the FCC Certification and negate your
right to operate the product.
Porter-Cable Corporation
4825 Highway 45 North
Jackson, TN 38305
Copyright © 2002, All rights reserved.
GENERAL MAINTENANCE
KEEP TOOL CLEAN
All plastic parts should be cleaned with a soft damp cloth. NEVER use
solvents to clean plastic parts. They could very possibly dissolve or otherwise
damage the material.
FAILURE TO OPERATE
Should your laser square fail to operate, make sure batteries are charged and
properly installed.
BATTERY
The batteries will discharge if stored for long periods of time, and may require
replacement before use.
SERVICE AND REPAIRS
All quality tools will eventually require servicing or replacement of parts due
to wear from normal use. These operations, should ONLY be performed by
either an AUTHORIZED PORTER-CABLE SERVICE STATION or a PORTER-
CABLE
• DELTA FACTORY SERVICE CENTER. All repairs made by these
agencies are fully guaranteed against defective material and workmanship.
We cannot guarantee repairs made or attempted by anyone other than these
agencies.
Should you have any questions about your laser square, feel free to write us
at any time. In any communications, please give all information shown on the
nameplate of your laser square (model number, type, serial number, etc.).