Filter
Top Products
9
Troubleshooting
When the…
LED does not come on
when Lens Cover is up.
LED and Laser blink
continuously.
Remote Control will not
drive the Base Unit.
Laser & LED shut off
without warning blinks.
Base Unit will not move
on Adjusting Base.
The batteries in the Base Unit may need to be
changed. Change the batteries, then turn the Base
Unit on again.
Laser is out-of-level, or has been knocked out-of-
level. Move the Base Unit on the Adjusting Base until
both the LED and Laser quit blinking. Use the Remote
Control to rotate the Base Unit 360°, making sure the
Laser/LED do not blink at any time during the rotation.
Change the battery in the Remote Control. If the
problem persists, change the batteries in the Base
Unit.
Check batteries in the Base Unit. Prolonged exposure
to extremely high temperatures (120° F +) may cause
the laser to overheat. This will cause the self-
protection circuit in the Base Unit to shut down.
The Base Unit has been mounted to a screw longer
than 5/8". This could cause damage to the Adjusting
Base.
Specifications
Accuracy: +/- 1/8" @ 100' (radius)
Self-leveling: Level range +/- 10°; flashing out-of-level indicator
Remote Control: 3 speeds (low, medium & high); range – 100'
radius and 200' diameter
Range: Laser visibility up to 100' (indoor & outdoor – no
detector required); full 360° rotation
Pendulum Lock: Protects pendulum during transportation
and storage for added durability
Line Generation Feature: Converts laser beam to line of bright dots
Recalibration: On the jobsite
Environmental: Dust, dirt and water resistant
Laser Diode: Class IIIA 635nm
Tripod Mount: 1/4" x 20 & 5/8" x 11, (can be used without tripod; tripod not
included)
Warranty: 1 year limited
Power Supply: Base unit – 4 “AA” batteries; remote control – 9 volt battery
(not included)
Made In China