Filter
Top Products
13
9. Loosen the nuts on the four motor mounting
bolts (Fig. 4), and tension the v-belt by
pushing down on the motor. Tighten the four
motor mounting nuts.
The v-belt is properly tensioned when finger
pressure between the two pulleys causes
approximately 1/2" deflection (Fig. 4a).
10. Screw the two small knobs (Fig. 5) into the
threaded holes in the saw body. Slide the
pulley cover down over the knobs, and tighten
the knobs.
11. Attach trunnion support to saw body with two
M8 x 30 hex cap screws and two M8 lock
washers (A, Fig. 6).
12. Thread nut (B, Fig. 6) onto table stop bolt (C,
Fig. 6) and attach to trunnion support as
shown.