Filter
Top Products
19
14. For resawing operations attach the resaw
guide (Fig. 20) to the fence with the knob.
There is a slotted hole in the fence that will
accomodate the resaw kit. Position the resaw
guide so that it is centered with the front edge
of the saw blade. The resaw guide will give
you a taller, single-point contact surface
during resawing.
Tilting the Table
WARNING
Unplug the machine from the power
source before making any repair or adjustment!
Failure to comply may cause serious injury!
1. Loosen the two lock knobs (A, Fig. 21).
2. Tilt table up to 45 degrees to the right. The
angle is indicated on the trunnion scale.
3. Tighten the two lock knobs (A, Fig. 21).
Adjusting 90°
°°
° Table Stop
1. Disconnect machine from power source.
2. Loosen lock knobs (A, Fig. 21) and tilt table to
the left until it rests against the table stop (B,
Fig. 21).
3. Use a square placed on the table and against
the blade, as pictured in Fig. 22, to see if the
table is 90 degrees to the blade.
4. If an adjustment is necessary, tilt the table out
of the way and tighten the lock knobs (A, Fig.
21).