Filter
Top Products
10
Assembly
Attaching Leveling Feet
1. From the loose parts bag find the following items:
4 Leveling feet
8 Hex nut 3/8-16
2. From the loose parts find the following items:
4 Leg
3. Put a hex nut on each of the leveling feet and screw it
down towards the rubber foot.
4. Put the leveling feet through the holes in the bottom of
each leg.
5. Put another hex nut on each of the leveling feet and
hand tighten until they are next to the bottom support
of the leg.
WARNING: To reduce the risk of injury from unex-
pected saw or work movement, leveling feet must be
adjusted so that saw does not rock. After the band saw
has been attached to the legset, it will be necessary to
adjust the leveling feet so the saw does not rock.
Assembling Leg Set
1. From the loose parts bag find the following hardware:
40 Carriage Bolts M8 x 1.25-16
40 M8 Washers
40 M8 Lockwashers
40 M8 Nuts
2. From the loose parts find the following items:
4 Legs (With Attached Leveling Feet)
2 Stiffeners (short)
2 Stiffeners (long)
1 Stand top
3. Place stand top upside down on a level surface. Fas-
ten four legs to top using carriage bolts, washers, lock
washers, and nuts, as shown (with nuts and washers
to the inside). Note: Legs fasten to outside of top. Do
not tighten at this time.
4. Fasten two long stiffeners and two short stiffeners to
stand legs using carriage bolts, washers, lockwashers,
and nuts, as shown. Finger tighten only at this time.
M8
M8 Nut
Stiffener (Long)
Stiffener
M8
(Short)
Washer
Lockwasher
Carriage
Bolt
Leg
Stand Top
Leveling Foot
Hex Nut 3/8-16
Leg
Leveling Foot
Hex Nut 3/8-16
Leg
Washer M8
Lockwasher
Nut Hex M
8
Stand Top
M8
Bolt Carriage
M8 x 1.25-16
Legs
Stiffener (Short)
Stiffener (Long)