Filter
Top Products
8
Unpacking and Checking Contents
Tools Needed
Unpacking
WARNING: To reduce the risk of injury from unex-
pected starting or electrical shock, do not plug the
power cord in until all assembly and alignment steps
are complete. The power cord must remain unplugged
whenever you are working on the saw.
1. Separate saw and all parts from packing materials
and check each one with the illustration and the “List
of Loose Parts” to make certain all items are
accounted for, before discarding any packing material.
WARNING: If any parts are missing, do not attempt
to assemble the band saw, plug in the power cord, or
turn the switch on until the missing parts are obtained
and are installed correctly.
2. Sometimes small parts get lost in packaging materials.
Do not throw away any packaging until your saw is put
together. Contact 1-866-539-1710 if any parts are
damaged or missing.
List of Loose Parts
Item Description Qty.
A Band Saw ...........................................................1
B Motor w/Switch ...................................................1
C Table Asm...........................................................1
D Plate Support......................................................1
E Pulley Cover .......................................................1
F Trunnion Support................................................1
G V-Belt..................................................................1
H Stand Top ...........................................................1
J Legs....................................................................4
K Stiffener (Long)...................................................2
L Stiffener (Short) ..................................................2
M Bag Loose Parts ................................................. *
N Operator’s Manual..............................................1
* Number varies: bags can contain other smaller bags.
NOTE: To make assembly easier keep contents of each
bag together and separate from contents of other bags.
NOTE: To reduce the risk of damage to the band saw
leave it laying on its side in the shipping box until you are
ready to mount it to the leg set.
Combination Wrenches
10mm, 12mm, 13mm, 14mm
Combination Square Must be True
Draw Light
Line on Board
Along this Edge
Straight Edge of
Board 3/4” Thick
This Edge Must be
Perfectly Straight
Should be no Gap or Overlap when Square
is Flipped Over in Dotted Position
#1 Phillips Screwdriver
Adjustable Wrench
Combination Square
Straightedge
#2 Phillips Screwdriver
NOTE: The square and straight
edge are used to align the saw.
They must be accurate if the
saw is to be aligned properly.
F
C
D
G
H
J
K
L
N
E
A
B
M