Filter
Top Products
11
ASSEMBLY
INSTALLING THE DIPSTICK
See Figure 4.
The air compressor has a label installed between the oil fill
hole and a travel cap. Before using the unit the first time,
remove travel cap and label and insert supplied dipstick.
Make sure to add oil before first use. See Checking the Oil
before first time operation.
CHECKING THE OIL
See Figures 4 - 5.
Always check the oil when the unit is sitting on a level surface
and before first use.
Insert the dipstick into the oil fill hole completely. Remove
the dipstick and check the oil level.
Make sure the reading is between the MIN and MAX
reference levels on the dipstick.
NOTE:
Never let the oil drop to a level lower than MIN.
Maximum level is reached when the oil reaches the MAX
level reference on the dipstick.
Reinsert the dipstick securely into the oil fill hole.
To add oil:
Remove the dipstick.
Using a funnel, carefully pour oil into the oil fill hole. Refill
only with synthetic oil SAE 5W50.
NOTE: Avoid using too much oil. Ensure that the level of
the oil does not exceed the maximum reference level on
the dipstick.
Reinsert the dipstick securely into the oil fill hole.
INSTALLING THE SEMI-PNEUMATIC TIRE
See Figure 6.
Insert supplied axle rod through hole in semi-pneumatic
tire hub, centering the tire between the two center holes
in the axle rod.
Insert washers onto axle rod on either side and slide hitch
pins through both holes on either side of semi-pneumatic
tire to secure semi-pneumatic tire to the center of the axle
rod.
Insert tire rod (with semi-pneumatic tire installed) end
through metal bracket on the front of the air tank.
Insert the other axle rod end through metal bracket on
the opposite side.
Align the holes on the axle rod end with the slots in the
metal brackets and install supplied screws through the
lined up holes.
SEMI-PNEUMATIC TIRE
ON
OFF
O
I
ON
ADD OIL BEFORE START.
Remove cap,
add oil and insert dipstick before start up.
APPOINT D’HUILE PREMIER
DÉMARRAGE.
Retirer bouchon,
appoint d’huile et insérer jauge
d’huile premier démarrage.
ABASTECER DE ACEITE ANTES
DE ARRANCARLO.
Retire la tapa,
abastecer de aeite y introduzca la tap
a,
antes de arrancarlo.
0
2
4
6
40
80
120
160
bar
0
2
4
6
40
80
120
160
bar
ON
OFF
O
I
1
TM
2
MINI WHEELBARROW COMPRESSOR
OIL LUBE PUMP
-
POMPE A HULE - BOMBA CON LUBRICACION DE ACI
ETE
5 Gallon
18,8 Litre
18,7 Litro
4.4 SCFM @ 90PSI
0,12 m /Min @ 621 kPa
0,12 m /Min @ 6,21 bar
145 Max PSI
999 KpA
9,99 bar
3
3
T
A
N
Q
U
E
-
T
A
N
K
-
R
E
S
E
V
I
O
R
E
N
C
H
U
F
E
-
T
A
N
K
-
S
O
R
T
I
E
Fig. 4
LABEL
DIPSTICK
Fig. 6
WASHER
HITCH PIN
METAL
BRACKET
DIPSTICK
Fig. 5
REFERENCE
LEVEL MARKS
SCREW
AXLE ROD
MAX
MAX REFERENCE MARK
OIL FILL HOLE