RIDGID OL50145MW Air Compressor User Manual


 
12
ON
OFF
O
I
ON
0
2
4
6
40
80
120
160
bar
0
2
4
6
40
80
120
160
bar
1
TM
2
MINI WHEELBARROW COMPRESSOR
OIL LUBE PUMP
-
POMPE A HULE - BOMBA CON LUBRICACION DE AC
IETE
OPERATION
DANGER:
Do not disassemble check valve, tank drain valves
or safety relief valve with air in tank — bleed
tanks.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses with
side shields when operating products. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
WARNING:
Do not attach any tools to the open end of the hose
until start-up has been completed.
CAUTION:
Do not use in an environment that is dusty or
otherwise contaminated. Using the air compressor
in this type of environment may cause damage to
the unit.
APPLICATIONS
Air compressors are utilized in a variety of air system
applications. Match hoses, connectors, air tools, and
accessories to the capabilities of the air compressor.
You may use this product for the purposes listed below:
Operating some air-powered tools
Operating air accessories such as air nozzles and
inflators
ATTACHING A HOSE
See Figure 7.
Make sure the air compressor is off and unplugged.
Rotate pressure regulator knob fully counterclockwise.
Attach hose with male connector to quick connect
Fig. 8
ON/OFF
SWITCH
universal fitting on air compressor. Make sure to push the
hose adapter end fully into the coupler until the sleeve
springs forward to lock it in place.
TURNING THE AIR COMPRESSOR ON/OFF
See Figure 8.
With the air compressor plugged in, pull the power switch
to the ON position to power the compressor on.
To turn the air compressor off, push the power switch to
the OFF position.
NOTE: When the compressor is in the ON position, the
air compressor will automatically turn back on when the
designated tank air pressure drops below the preset pressure
limit. It will also shut off again when the desired pressure
is reached.
USING THE AIR COMPRESSOR
See Figures 9 - 10.
Ensure power switch is in the OFF (O) position and air
compressor is unplugged.
If not already installed, attach hose to compressor as
previously instructed.
Fig. 7
FEMALE COUPLER
HOSE
ADAPTER END
PRESSURE
REGULATOR KNOB
(I) ON
(O) OFF
TO
CLOSE