Filter
Top Products
Page 11
0
15
30
45
15
45
0
ADJUSTMENTS
Fig. 6
ADJUSTABLE FLIP FENCE
See Figure 6.
The adjustable flip fence is located at the rear of your cut-off
machine. As mentioned previously, it is used along with the
vise clamp to provide a clamp for holding your workpiece
securely when making cuts. It also makes your cut-off
machine more versatile.
The fence can be rotated to obtain cutting angles from 0° to
45°. It also has an extension block that flips up to allow
greater cutting widths in thin stock, or down to allow greater
cutting depths in tall or thick stock.
CUTTING ANGLE ADJUSTMENT
See Figure 6.
■ Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
■ Loosen the fence lock handle securing fence assembly.
■ Rotate fence assembly until the desired angle of cut on
the scale is aligned with the indicator in machine base.
■ For precise cuts, check the angle of cut for the fence
against the abrasive wheel with a protractor, bevel square,
or other similar device.
■ Using the fence lock handle, securely tighten the fence
in place at desired angle.
See Figure 6.
ADJUSTING WIDTH OF CUT
See Figures 7 and 8.
■ Unplug your cut-off machine.
WARNING:
Failure to unplug cut-off machine could result in accidental
starting causing possible serious personal injury.
■ To increase the width of cut of your cut-off machine, flip
the extension block up and back as shown in figure 7.
This position is good for cutting thin and wide pieces of
stock, such as flat or angled stock.
■ To increase the height of cut of your cut-off machine, flip
the extension block down as shown in figure 8. This
position is good for cutting tall and thick pieces of stock,
such as square or tube stock.
Fig. 7
Fig. 8
ADJUSTABLE
FLIP FENCE
SCALE
INDICATOR
EXTENSION
BLOCK
EXTENSION
BLOCK
ADJUSTABLE
FLIP FENCE
ADJUSTABLE
FLIP FENCE
FENCE LOCK
HANDLE
FENCE
SCALE
VISE
CLAMP