Filter
Top Products
Page 17
OPERATION
WARNING:
Do not allow familiarity with your saw make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
BEFORE LEAVING THE SAW
See Figure 16.
■ Wait until the saw has come to a full and complete stop.
■ Place the switch in the OFF position, remove the switch
key from the switch assembly. Store key in a safe place.
■ Unplug the saw from the power source.
■ Make workshop childproof.
■ Lock the shop.
LOCKING THE SWITCH
See Figure 16.
■ Wait until the saw has come to a full and complete stop.
■ Place the switch in the OFF position, remove the switch
key from the switch assembly. Store key in a safe place.
TILTING THE TABLE
See Figure 17.
■ Loosen the table lock handle slightly.
■ Turn the angle adjustment knob, tilting the saw table
toward the front of the saw housing until it reaches the
desired angle.
■ Using the scale indicator, check angle markings.
■ Retighten the table lock handle to hold saw table securely
in place.
USING THE MITER GAUGE
See Figure 18.
The miter gauge can be turned 45° to the right or left.
■ Loose the lock knob on the miter gauge.
■ With the miter gauge in the miter gauge slot, rotate the
gauge until the desired angle is reached on the index
scale.
■ Retighten the lock knob.
Fig. 17
0
15
45
TABLE LOCK
HANDLE
SCALE
INDICATOR
SAW
TABLE
Fig. 18
3
2
1
M
A
X
I
M
U
M
C
U
T
T
I
N
G
C
A
P
A
C
I
T
Y
O
N
R
E
M
O
V
E
TO
L
O
C
K
O
9
”
B
A
N
D
S
A
W
90
7
5
6
0
4
5
30
7
5
6
0
45
30
MITER
GAUGE
SLOT
LOCK
KNOB
MITER
GAUGE
Fig. 16
ON
O
N
R
E
M
O
V
E
T
O
L
O
C
K
O
9
”
B
A
N
D
S
A
W
3
0
45
60
7
5
9
0
7
5
6
0
4
5
3
0
O
N
O
FF
REMOVE
TO LOCK
OFF
SWITCH
KEY