Filter
Top Products
13
EACH 90
° ROTATION OF DEPTH
STOP KNOB EQUALS 1/64 in.
(0.4 mm) CHANGE IN DEPTH OF CUT
TO ADJUST DEPTH OF CUT USING OPTIONAL
DEPTH CONTROL KNOB
See Figure 9.
■ UNPLUG YOUR ROUTER.
WARNING:
Failure to unplug your router could result in acciden-
tal starting casuing serious injury.
■ Loosen lock knob and raise stop bar.
■ Unlock plunge lock lever and raise cutter to its up-
permost position.
■ Plunge router until cutter reaches the approximate
desired depth of cut.
■ Lock plunge lock lever, temporarily locking cutter at
desired depth of cut.
■ Turn depth control knob clockwise until hex nut seats
against stop flange. Do not overtighten.
■ Unlock plunge lock lever. Always unlock plunge
lock lever before setting depth of cut with depth
control knob.
■ Turn depth control knob until cuter reaches desired
depth of cut.
■ Lock plunge lever. Always lock cutter in place
before routing.
■ Loosen lock knob and adjust stop bar until it touches
depth stop.
■ Tighten lock knob securely.
DEPTH STOP
See Figures 10 and 11.
The depth stop is located on the base of your router and
makes it possible to make deep or heavy cuts in
successive passes by use of the Accu-Stop™ Micro-
Adjustable Depth Stop System. Alignment marks make
depth of cut changes quick and easy.
A preset cutting depth is achieved by plunging router
until stop bar comes in contact with depth stop. The
micro-adjusting feature provides alignment marks at
each 90° rotation of the depth stop knob. Each 90°
rotation of the knob changes depth of cut setting 1/64 in.
(0.4 mm).
See Figure 10.
A complete rotation (360°) of the depth stop knob changes
the depth of cut setting 1/16 in. (1.6 mm).
See Figure 11.
The Accu-Stop™ Micro-Adjustable Depth Stop System
provides for depth of cut changes to be made from 0 to
1/2 in. (12.7 mm) from the initial setting of the stop bar.
This initial setting of the stop bar can be "zero" depth of
cut, or it can be any depth of cut setting that you choose
as a starting point for a particular job to be performed.
EACH COMPLETE ROTATION
360° OF DEPTH STOP KNOB
EQUALS 1/16 in. (1.6 mm)
CHANGE IN DEPTH OF CUT
ADJUSTMENTS
DEPTH STOP
KNOB
ACCU-STOP
TM
MICRO-ADJUSTABLE
DEPTH STOP
STOP
BAR
LOCK
KNOB
Fig. 10
STOP
BAR
LOCK
KNOB
Fig. 11
ZERO RESET INDICATOR
WITH RED LINE
SCALE
Fig. 9
OPTIONAL DEPTH
CONTROL KNOB
DEPTH
ADJUSTMENT
ROD
COMPRESSION
SPRING
HEX NUT
PLUNGE
LOCK
LEVER