Filter
Top Products
13
ADJUSTMENTS
Fig. 11
WARNING:
The router or router table should never be con-
nected to a power supply when you are assembling
parts, making adjustments, installing or removing
cutters, cleaning, or when not in use. Disconnecting
the router and router table will prevent accidental
starting that could cause serious personal injury.
INSERTING/REMOVING CUTTERS
Follow these directions to insert and remove cutters.
Q Unplug the router and the router table.
WARNING:
Failure to unplug the router and router table could
result in accidental starting causing serious injury.
WARNING:
To prevent damage to the spindle or spindle lock,
always allow the motor to come to a complete stop
before engaging the spindle lock.
Q Remove the screws from the rear safety guard.
Q Remove the rear safety guard from the router.
Q Follow the directions for installing and removing
cutters in the operator’s manual.
WARNING:
Use this router table only with a Ryobi router. Do not
attempt to use any other router with this table. Fail-
ure to heed this warning could result in improper
operation of the tool and serious personal injury.
Q Return the rear safety guard to its proper position.
Q Secure the rear safety guard by inserting and tight-
ening the two screws previously removed.
WARNING:
If you are changing a cutter immediately after use, be
careful not to touch the cutter or collet with your hands
or fingers. They will get burned because of the heat
buildup from cutting. Always use the wrench provided.
ADJUSTING DEPTH OF CUT
See Figure 11.
We recommend that cuts be made at a depth not
exceeding 1/8 in. (3.2 mm) and that several passes be
made to reach depths of cut greater than 1/8 in. (3.2
mm).
Follow these directions to adjust depth of cut.
Q Unplug the router and the router table.
WARNING:
Failure to unplug the router and router table could
result in accidental starting causing serious injury.
Q Unlock the clamping lever.
Q Turn the depth adjusting ring until the tip of the
cutter touches the work surface (zero depth of cut).
Q Turn depth indicator ring to zero depth of cut on the
scale.
Q Turn the depth adjusting ring to the desired depth of
cut.
Q Lock the clamping lever securely.
NOTE: When you use certain cutters, you may need
to remove the black plastic subbase from the router
to achieve full depth of cut.