Filter
Top Products
REMOVING THE CHUCK
1. Open jaws of chuck as wide as they will go by
turning chuck sleeve.
2. Carefully tap chuck with mallet in one hand while
holding chuck in other hand to prevent dropping it
when released from spindle nose,
SLEEVE
DRILLING TO DEPTH
To drill a BLIND hole (not all the way through) to a
given depth, can be done two ways.
1. Mark the depth of the hole on the side of the work-
piece,
2. With the switch OFF bring the drill down until the
TIP or lips are even with the Mark.
3, Spin the lower nut down to contact the depth stop
lug on the Head,
4. Spin the upper nut down and tighten against the
lower nut.
DEPTH
STOP
MARK
/
ANOTHER WAY -- DEPTH SCALE
1. Turn the switch off.
2. Turn the feedhand_e until the pointer points to the
desired depth on the depth scale.
3. Hold the feed handle at this position.
4. Spin the lower stop nut down until it touches the
depth stop.
5. Spin the upper stop nut down against the lower
stop nut and tighten.
6. The chuck ordrill will now be stopped after traveling
downward the distance selected on the depth
scale.
DEPTH,
STOP
LOWER
STOP NUT
DEPTH
SCALE
UPPER
STOP NUT
18