Filter
Top Products
LayREARFENCE GUIDE BAR on table to act as a
straightedge. If outer edge of extension is higher or lower
than table surface;
A. Slightly loosen nuts holding bracket to extension
using 7/16 in. wrench.
B. Move end of extension up or down until outer edge
is even with table surface ... check with GUIDE
BAR .., tighten nuts.
C. Recheck INNER edge of extension to make sure it
has not moved ... readjust, if necessary.
INSTALLING RIP FENCE GUIDE BARS AND SWITCH
BOX
1. From among the loose parts find the following
hardware:
2 Hex. Head Screws, 5/16-18 x 1-3/4 in. long
2 Hex Head Screws, 5/16-18 x 1 in. long
1 Hex, Head Screw, 5/16-18 x 3/4 in. long
5 External Lockwashers, 5/16 in,
(approx. dia. of hole 5/16 in,)
5 Hex. Nuts. 5/16-18 (approx. die. of hole 5/16 in.)
2 Flat washers (dia. of hole 21/64 in,I
2 Spacers,3/4 in. dia. x 1/2 in. long
2 Self-threading nuts
1 Fence Guide Bar Rod
2. Lay guide bars on sawtable.
NOTE: The various holes in the bar allow them to be
positioned on this saw and also makes them adaptable
to other models.
3. Insert a1-3/4 in. long screw through the THIRD hole
from the LEFT IN THE FRONT BAR . . . insert
another 1-3/4 in. long screw through a flat washerand
/
!
then through the hole at EXTREME LEFT SIDE OF
SWITCH then through SEVENTH hole in bar. Hold
them in place with a piece of masking tape ... Insert
the 3/4 in. long screw through a flat washer and then
through hole at RIGHT SIDE OF SWITCH and then
through the EIGHT hole in bar. Install a Iockwasher
and nut and tighten.
4. Place spacers on screws.
Insert bolts through holes in middle and on right sideof
front of saw table ... install Iockwashers and nuts.
DONOr SCREW NUTS ON ALL THE WAY, just get
them started on the screws.
6=
7.
Remove the 3 screwsfrom rear of table extension.
Insert 1 in. long screws in SECOND and FOURTH holes
of rear bar and attach to table the same way.
Insert ends of FENCE GUIDE BAR ROD through
round holes at outer end of bars,
NOTE: The ends of the ROD are not threaded .., the
SELF THREADING NUTS will cut threads on the rod
asthey are screwed on.
\
10