Filter
Top Products
INSTALLING BELT GUARD
1. Remove the belt and motor pulley.
2. Screws furnished witli guard are "self threading" ...
screw them into holes in BELT GUARD SUPPORT
BRACKET, then remove them.
3. Position BELT GUARD SUPPORT BRACKET and
BELT GUARD SUPPORT as shown and install the
screws ... make sure motor shaft is in CENTER of
hole in SUPPORT.
_ _-_ TWO HOLES CLOSEST
TOGETHER
BELT GUARD
SUPPORT BRACKET
\
\
BELT GUARD SUPPORT
BELT GUARD
10-32 X 1/2 IN.
SEL.F-THREADING
SCREW
/
/
CENTERED
\
PIVOT
SCREW
4. Install three CLIPS (furnished with guardi 90 ° apart
starting with one clip at the end of the guard as shown
•.. LONG END of cl p facingAWAY from you.
BELT GUARD
OPENING
j__,_ CLIPS
N
LONG END
5. Reinstall ,motor pulley the same way it was when you
aligned the belt,
6. Place belt on SAW'PULLEY ,.. insert end of belt
through opening in END of guard,
7. Slip belt over motor pulley.
BELT.
18