Sears 113.298141 Saw User Manual


 
9 REMOVING AND INSTALLING SAWBLADE.
WARNING: FOR YOUR OWN SAFETY, TURN
SWITCH "OFF" AND REMOVE PLUG FROM
POWER SOURCE OUTLET BEFORE REMOVING OR
INSTAL LING SAWBLADE.
A. Raise Blade Guard...remove insert.
B. To REMOVE blade, place a block of wood
against front of blade ... PULL arbor wrench
toward you to LOOSEN arbor nut.
/
/
WOOD BLOCK
OR NUT
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
C. To TIGHTEN arbor nut, place a block of wood
against rear of blade ;.. PUSH wrench away
from you.
When installing the blade . .. make sure the teeth are
pointing toward the front of the saw ... and that the
blade and collars are clean, and free from any burrs.
The HOLLOW side of the collar must be against the
blade.
Always tighten the arbor nut securely.
NOTE: When using the Dado or Molding Head, itis not
necessary to install the loose collar.
To replace insert. LOOSE
Place insert into insert opening n table and push COLLAR
toward rear of saw to engage spring clip and unt, I AR,OR ff_,_
keyslot in insert will drop over screw. Tighten screw. _,
Do not tighten screw to the point where it will deflect (_"// _\ ARBOR
the insert, r _ _ _ _ _ _
TEETHFO,NT,.OTO'
FRONTOF SAW h _, v
NUT
NUT
10 EXACT-I-CUT
The ' yellow" plastic disc imbedded n the table in front
of the sawb!ade, isprovided for marking the location of
the sawcut on the workpiece.
A. Check disc ... if it is above table surface, place a
piece of hardwood on top of it and tap it down.
B. With blade 90° (square to table) cut off a piece of
wood.
C. Pull miter gauge back until wood isover disc. Using
very sharp pencil, mark a line on disc.
D With miter gauge in right hand groove, follow same
procedure and mark another line on disc BLADE GUARD NOT SHOWN FOR PICTURE CLARITY
in " " "" ""E. These I es mdlcate the path of the cut (kerf)
made by the sawblade.
F. When cutting the workpiece, ine up mark on
workpiece with line on disc.
22