Filter
Top Products
-35-
M1113 18" Wood/Metal Bandsaw
OPERATIONS
Fence Scale Calibration
You may need to recalibrate the fence scale after chang-
ing or adjusting the blade, or if the scale is not producing
accurate cuts. Recalibrate the fence scale by adjusting
the hairline indicator on the fence and testing your adjust
-
ment by cutting a piece of scrap wood.
To calibrate the scale, do these steps:
1. Set the fence anywhere along the scale and locate a
piece of scrap wood with at least one straight edge.
Note: Joint the edge with a jointer (if needed) to
make the edge
straight.
2. Hold the straight edge of the workpiece firmly
against the fence, and feed the workpiece through
the saw blade with a push stick.
3. Measure the width of the cut workpiece. The width
of the workpiece should match the reading on the
fence scale.
4. If the reading on the scale is not the same as the
width of the cut workpiece, loosen the screw on
the magnifying window (
Figure 48), and adjust it to
match the width of the cut workpiece.
5. Tighten the screw; the scale is now correctly cali-
brated.
Figure 48. Scale calibration screws.