Filter
Top Products
SAFETY
-5-
13. Use the correct tool. Do not force the tool or attachment to do a job for which it was not
designed.
14. Wear proper apparel. Do not wear loose clothing, gloves, jewelry, keep long hair tied up, etc.
15. Remove adjusting keys and wrenches. Before turning the machine on, make a habit of checking
that all adjusting keys and wrenches have been removed before turning the machine ON.
16. Use proper extension cord. Examine the extension cord to ensure it is in good condition. Use
Table 1 below to determine the correct length and gauge of extension cord needed for your
particular needs. The amp rating of the motor can be found on its nameplate. If the motor is dual
voltage, be sure to use the amp rating for the voltage you will be using. If you use an extension
cord with an undersized gauge or one that is too long, excessive heat will be generated within the
circuit increasing the chance of a fire or damage to the circuit. Never use an extension cord that
does not have a ground pin and connected ground wire. Immediately replace an extension cord if
it shows any signs of damage.
17. Keep stable footing and balance at all times.
18. Do not leave machine unattended. Wait until it comes to a complete stop before leaving the
area.
19. Perform machine maintenance and care. Follow lubrication and accessory attachment
instructions in the manual.
20. Keep machine away from open flame. Operating machines near pilot lights and/or open flames
creates a high risk if dust is dispersed in the area. Dust particles and an ignition source may cause
an explosion. Do not operate the machine in high-risk areas, including but not limited to, those
mentioned above.
21. If at any time you are experiencing difficulties performing the intended operation, stop using the
machine! Then contact our Service Department or ask a qualified expert how the operation should
be performed.
22. Habits—good and bad—are hard to break. Develop good habits in your shop and safety will
become second-nature to you.
Operating this equipment creates the
potential for flying debris to cause eye
injury. Always wear safety glasses or
goggles when operating equipment.
Everyday glasses or reading glasses only
have impact resistant lenses, they are not
safety glasses. Be certain the safety glasses
you wear meet the appropriate standards of
the American National Standards Institute
(ANSI).
Length And Gauge
Amp Rating 25ft 50ft 100ft
0-6 #16 #16 #16
7-10 #16 #16 #14
11-12 #16 #16 #14
13-16 #14 #12 #12
17-20 #12 #12 #10
21-30 #10 #10 No
Table 1
Extension Cord Requirements