Filter
Top Products
-15-
N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/
J<KLG
((% Place the pulley cover over the motor and gear
shafts, and secure it with the pre-installed M6-1 x
12 Phillips head screws and 12mm flat washers, as
shown in =`^li\(*.
()% Open the pulley cover, then insert the keys into the
slots on the pulley shafts.
(*% Slide the large diameter motor pulley onto the motor
shaft (see =`^li\(+).
(+% Install the worm gear pulley with the small diameter
wheel on the shaft closest to the gear box.
(,% Use a straightedge to check the alignment of the
pulley wheels, as shown in =`^li\(,, and adjust
them as needed.
(-% When the pulley wheels are aligned, tighten the set
screws on both pulleys.
=`^li\(*% Installing the pulley cover.
=`^li\(+% Motor pulley installed.
Motor Pulley
w/Key Slot
=`^li\(,% Checking the pulley alignment.