Filter
Top Products
-16-
N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/
J<KLG
(.% Unthread the V-belt tension hex bolt, then pivot
the motor up and slide the V-belt into the pulley
grooves, as shown in =`^li\(-.
(/% Release the motor, letting its weight tension the
V-belt, then thread the V-belt tension hex bolt
against the side of the bandsaw.
(0% Install the work stop shaft into the side of the
bandsaw then lock it in place by tightening the set
screw, as shown in =`^li\(..
)'% Slide the work stop onto the end of the shaft and
lock it into position with the locking lever, as shown
in =`^li\(/.
=`^li\(.% Installing the work stop shaft.
=`^li\(/% Work stop locking lever
installed.
Locking
Lever
=`^li\(-% Installing the V-belt.
V-belt Tension
Hex Bolt