Filter
Top Products
-30-
N(.(,Fne\ijDXelXcD]^%J`eZ\)&'/
J<IM@:<
9cX[\:_Xe^\
Blades should be changed when they become dull,
damaged, or when your operation requires a different
blade.
KfZ_Xe^\k_\YcX[\fek_\YXe[jXn#[fk_\j\jk\gj1
(% DISCONNECT BANDSAW FROM POWER!
)% Raise the head of the bandsaw to the vertical
position, use the head locking pin to hold it in place,
then remove the wheel access cover.
*% Loosen the tension knob and slip the blade off of the
wheels.
+% Install the new blade through both blade guide
bearings, as shown in =`^li\+*, and around the
bottom wheel.
,% Hold the blade around the bottom wheel with one
hand and slip it around the top wheel with the other
hand, keeping the blade between the blade guide
bearings.
Efk\1 @k`jjfd\k`d\jgfjj`Yc\kf]c`gk_\YcX[\
`ej`[\flk#`en_`Z_ZXj\k_\YcX[\n`ccY\`ejkXcc\[
`ek_\nife^[`i\Zk`fe%:_\ZbkfdXb\jli\k_\
YcX[\k\\k_Xi\]XZ`e^kfnXi[k_\nfibg`\Z\#Xj
j_fne`e=`^li\++#X]k\idflek`e^kfk_\YXe[jXn%
Jfd\YcX[\jn`cc_Xm\X[`i\Zk`feXcXiifnXjX
^l`[\%
-% When the blade is around both wheels, adjust the
position so the back of the blade is against the
shoulder of the wheels (see =`^li\+,).
.% Tighten the tension knob so the blade will not slip on
the wheels upon start up.
/% Connect the bandsaw to the power source.
0% Briefly turn the bandsaw FE then F== to position
the blade and resume the previous tracking.
—If the tracking needs to be adjusted, see 9cX[\
KiXZb`e^ in the next section.
—If the tracking is fine, proceed to 9cX[\K\ej`fe on
GX^\*).
=`^li\+*% Installing the blade.
Blade
Guide
Bearings
Blade Travel
=`^li\++% Correct blade travel.
=`^li\+,% Blade installed on the top
wheel.
Shoulder
J<IM@:<