Filter
Top Products
-9-
W1751 25" Wide-Belt Sander
ELECTRICAL
ELECTRICAL
220V Operation
The Shop Fox Model W1751 has a 7.5 HP, 32A, 220V
single-phase sanding motor, and a
1
⁄4 HP, 1.8A, 220V
feed motor. Hardwire your machine to a power panel
(Figure 1) that is rated for at least 50 amps.
We recommend connecting this machine to a dedicated
circuit with a verified ground, using the circuit breaker
size given below. Never replace a circuit breaker with
one of higher amperage without consulting a qualified
electrician to ensure compliance with wiring codes.
If you are unsure about the wiring codes in your area
or you plan to connect your machine to a shared cir
-
cuit, you may create a fire hazard—consult a qualified
electrician to reduce this risk.
We do not recommend using an extension cord for 220V
operation. When it is necessary to use an extension cord,
use the following guidelines:
• Use cords rated for Standard Service
• Never exceed a length of 50 feet
• Ensure cord has a ground wire and pin
• Do not use cords in need of repair
• Use no smaller than 6 gauge cords
Extension Cords
Grounding
This machine must be grounded! Verify that any exist-
ing electrical outlet and circuit you intend to plug into
is actually grounded. If it is not, it will be necessary to
run a separate copper grounding wire, of the appropri
-
ate size, from the outlet to a known ground. Under no
circumstances should you connect your machine to an
ungrounded power source or electrocution or sever
e
shock could occur.
DO NOT attempt to work on your shop
electrical system if you are unsure
about electrical codes and wiring!
Seek assistance from a qualified elec
-
trician. Ignoring this warning can cause
electrocution!
TURN OFF and LOCK your
master power switch so
no power is available
to the sander before
connecting electrical
wires! If you ignore this
warning serious electrical
shock may occur causing
injury or death!
OFF
Operating Voltage Amp Draw Min. Circuit Size Connection Type Extension Cord
220V Operation 34 Amps 50A Hardwire
w/Shutoff Switch
Not
Recommended
Figure 1. Recommended connection type.